Tractor Talk Discussion Board |
Re: Weight of metal table
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JDknut on August 22, 2006 at 03:44:07 from (152.119.204.78):
In Reply to: Weight of metal table posted by 37 chief on August 21, 2006 at 23:59:50:
3/8" plate is 15.3 lbs per square foot, 3/4" plate is 30.6, the two together is 45.9. 4 x 8 = 32 square feet, so the total is 45.9 x 32 = 1468.8 lbs for the top plates alone, figure at least 500 lbs for framing heavy enough to carry it, so you are talking about a ton. Even a Ford F-350 with a powerjoke should handle it :-)
Replies:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|