|
Tractor Talk Discussion Board |
Re: Weight of metal table
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dab on August 22, 2006 at 02:33:16 from (216.163.34.34):
In Reply to: Weight of metal table posted by 37 chief on August 21, 2006 at 23:59:50:
General rule of solid metal is lenght x width x thickness x .2836. Take these measurments in inches. This will get you real close. But take it right down to the 1/32 if your scale will read that good. Other wise 1/16 on a tape measure will work also. As was already stated take into account for the stand also. Formula for angle iron is a little more to it so if you e-mail me I can give you rough numbers for that also.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
