Tractor Talk Discussion Board |
Re: Storage bin prices?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by super99 on August 17, 2006 at 18:16:28 from (207.144.199.122):
In Reply to: Storage bin prices? posted by Dave from MN on August 17, 2006 at 08:07:46:
I would suggest looking for a used Gov't bin. 18 ft. dia.,about 4000 bu. Small enough that they can be laid on their side and moved to your site, just need to find route with no low power lines. Lot of work to tear down and move but if you have plenty of help, not that bad. Paint a line from floor to ceiling inside bin and number each sheet and ring and put it back together the way it came apart. should be able to rent bin jacks for a week. Several guys around here are set up to move 18 ft or smaller bins. Check around. my 2 cents worth. Chris
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|