Tractor Talk Discussion Board |
ot ,,Track Hoe conversion to Hydro drive ????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bryan in Iowa on August 12, 2006 at 17:51:36 from (152.163.100.74):
I have an old Little Giant track hoe that i am making usable again . The bevel drive gears for the crawler drive are shot. Tried to find gears , thought about welding up etc. Light bulb clicked other night, why not switch it to hydraulic drive ? It has 2 17gpm pumps on it . There is a shaft where the gear to track drive goes. Why not mount a pump coupled to that shaft ? No idea what i need to make this work though. Not to worried about travel speed , as anything is better than what i have now . Forward , reverse , motor , control valve , supply and return lines / Any ideas or suggestions ? Thanks Bryan
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|