Re: O.T. Buick Transmission removal

Posted by Allan In NE on August 05, 2006 at 21:31:04 from (148.78.243.25):

In Reply to: O.T. Buick Transmission removal posted by IA Roy on August 05, 2006 at 19:06:30:

Roy,

Support the engine by hanging it from a bar(s) teed across the strut towers and the radiator support. Then split the frame at the right front and left rear corners and get that half of it completely out of your way. Remove the left front strut.

Take the right wheel off, there are bolts in the end of the right tranny output shaft housing that have to come out anyway along with that speed sensor connector.

To get at that bolt that is hidden on the bell housing, I use a long four foot extension to reach in between the motor and the transmission case from the passenger side. Takes an 18mm socket just like all the rest of 'em.

That crossover pipe has to come off anyway; leave the both manifolds in place tho. The bell housing won't clear with the crossover pipe in place.

Soak those manifold studs on the crossover real good with panther juice.

Allan

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]