Tractor Talk Discussion Board |
Re: Elect. Motor hook-up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on August 01, 2006 at 17:10:19 from (66.244.90.5):
In Reply to: Re: Elect. Motor hook-up posted by John M on August 01, 2006 at 16:53:34:
In the typical Motor Starter the low current "coil" could be fed from one leg of the 240 line voltage and then in series with maybe a pressure switch and the push to start hold in contactor and the thermal cutouts and then over to the other phase leg to complete the loop. Once the push to start switch activated the hold in relay in paralell with it and provided the pressure switch was closed and none of the thermals were opened, she would engage the power contactors. It would be easier if I were smart enough to include a wiring diagram, I will look n see if I have one. Basically yes you use the line voltage to power the activation coil buttttttttttt theres the pressure switch and the thermal overloads and the push to start switch and its paralell contactor alllllll in series between the phase conductors in the low current coil activation circuit. John T
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|