|
Tractor Talk Discussion Board |
Re: Super A wiring diagram/6volt to 12 volt
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on July 30, 2006 at 15:33:06 from (4.244.186.220):
In Reply to: Super A wiring diagram/6volt to 12 volt posted by Robert Switzer on July 30, 2006 at 15:24:46:
From what your saying you have a 1 wire alternator and tha is the easies set up there is. You run the wire from the alternator to the battery or amp gauge which ever you want. Because the amp gauge should also have a wire going to the battery any how so its sort of the same place any how. As far as the ballast resistor getting hot yep they will thats sort of how it works. Now the coil should get warm but not so hot you can't touch it. Also you need to switch the wires on the coil so the + side goes to the switch and the - side goes to the distubutor. You also have to have the battery hooked up for - ground or the alternator will fry
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|