|
Tractor Talk Discussion Board |
Re: oliver 1600 stuck in reverse
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by J Schwiebert on July 30, 2006 at 05:19:47 from (209.143.51.251):
In Reply to: oliver 1600 stuck in reverse posted by David Schlag on July 29, 2006 at 20:29:37:
Take the steel plate off unless you can lift the shift lever off without doing that. To take the transmission cover off as was mentioned below involves removing the complete hydraulic unit, I would try my suggestion first. There are 2 springs under there that center the shifter handle. Take a flash light and look in there. The slots for the 3 rails will not line up. Take a small pry bar or big screw driver and pop the rail forward so that the slots line up. Questions find me on the Oliver or www/hpoca.org form. J.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
