Re: 12 volt conversion for MM RTI

Posted by El Toro on July 22, 2006 at 07:52:31 from (64.12.116.74):

In Reply to: 12 volt conversion for MM RTI posted by Dave Skirmont on July 22, 2006 at 06:24:15:

If you're going to use an alternator it will be negative - grounded. If this is battery ignition
with a distributor you will need to use a ballast resistor between the ignition switch and the coil
to drop the voltage to 6 volts. If you go to neg
ground your coil needs to have the coil wire from the - Neg terminal on the coil to the distributor.
The light bulbs would need to be changed too.
If your solenoid feeds voltage to the ignition switch it probably would need to be changed. Hal

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]