|
Tractor Talk Discussion Board |
Wisconsin v4 fuel pump leak
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by paul on July 17, 2006 at 18:42:02 from (66.60.197.179):
Got 10 acres of oats left to cut, & the fuel pump is running out fuel in a constant stream out the 'leak holes'. Obviously the diaphram is rotted through. It's a round pump, lever activated, even has a manual finger pumper on it. I took it apart, & the diaphram is connected to the lever in the middle of the pot metal. How do I disconnect the diaphram from the lever? Lever is all riveted togother so it won't follow through after the diaphram; they must disconnect somehow but no room to get in & do so? Then, will I even be able to get a diaphram any more for this old cast iron engine? It goes way back, actually dad got it off an old Woods corn picker, put it on the swather. Magneto; no charging system on this, tho I do have a 6v battery riding along to run the starter a few times. So, electric conversion would be messy, I'd just like to figure out the diaphram pump? --->Paul
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|