Tractor Talk Discussion Board |
Re: Tractor Shed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 720Deere on July 14, 2006 at 08:48:30 from (63.138.125.15):
In Reply to: Re: Tractor Shed posted by Danny Prosser on July 13, 2006 at 12:14:44:
Don't put the wire "in the bottom". If you ever watch professionals pour concrete over wire, you will see them pull the wire up into the middle of the concrete. The wire mesh will give no support on the bottom of the concrete. Another method would be to set the wire on "chairs" as they do with rebar, but it's not as easy as rebar because the wire is not rigid enough to support itself.
Replies:
Home
| Forums
Today's Featured Article -
Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|