|
Tractor Talk Discussion Board |
Welding question - quick one, safely grounding on
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on July 11, 2006 at 10:15:24 from (205.188.117.14):
Parts came in for the exhaust on my old F-600, have one broken exh. manifold bolt, funny how the rest came out easy, and I think I've got enough to let a nut hang on what is sticking out, I think I will weld the nut to the broken bolt, hoping the heat and grip I'll get will help carefully work that bolt out. Question is, if I clamp off on an adjacent bolt, will that be close enough to avoid stray voltage from arcing, say like connecting rods and bearings below which I know can happen if you are not careful. I'm thinking this should not be a problem if grounded close to the work, this old Y-block 292 runs good, lot of oil pressure etc. don't want to screw it up if you know what I mean, I'll try other methods if too risky. Thanks again !
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
