|
Tractor Talk Discussion Board |
Getting ready to go back to the hills
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill46 on July 07, 2006 at 12:28:38 from (63.65.68.246):
Well...about had it with the heat and the rain down here...about to grow web feet.
Been moving stuff around to make room for the new-old tractor I bought. Thought I might try and start the Super MTA. Just changed all the oil and put in new filters. Got tired of carrying transmission oil.
Anyway, put new fuel filters on it and decided to to try it before we hooked a chain to move it.
Old gal fired right up on gas...took a few trys to get her to run on diesel but she finally hit on 2. Cracked the injector lines and she started to run better. Got all four hitting so took her for a little ride.
It runs and pulls ok, TA seems ok, but the rear end sure is loud in road gear...a lot louder than the 450D.
Anyway...shes running and I have her inside out of the weather for now.
Have a great weekend all. Got to get ready to go to the Hoosier state next week.
Lady friend has never been out of the flat lands...she will go nuts in those hills.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
