Tractor Talk Discussion Board |
Re: When to mow oats for hay?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on July 02, 2006 at 07:43:16 from (152.163.100.74):
In Reply to: When to mow oats for hay? posted by IaGary on July 02, 2006 at 05:05:57:
When we typically cut it, it covers everything in a rust coloed dust. Not sure for the technical term for the stage. We just put some peas, tritical, and oats in the silo this week. While the peas and oats weren't quite as far as we like, the tritical just took off with all the moist hot weather we've been having. We got 7 loads off about 6 acres. Originally it was just going to be peas & tritcal, but I started running low on seed and I was already done seeding down the oats, so I dumped in a few bags of oats so I could finish the feild.
So far i think the feed is turning out nicely in the silo. We put it up with 1/2 bag of dried molasis per load to sweeten things up a bit, and the girls are starting to eat it better now that it's cooked in the silo for almost a week. Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|