|
Tractor Talk Discussion Board |
Re: 29 Modle D governor problembs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Butch 1 cow on June 28, 2006 at 18:09:09 from (65.25.139.234):
In Reply to: 29 Modle D governor problembs posted by Brian's29D on June 28, 2006 at 17:38:58:
With the throtle lever pulled all the way back and the carb butterfly in the closed position. the rod should be adjusted so that it will slide into position on both ends without binding. The 3 holes in the rod are for RPM adjustment only. The less tension on the spring the lower the engine speed. Speed must not exceed 850 without a load. 800 under load. Look for a bind in the linkage. Make sure the rod comming out of the gov. case moves freely. Check the carb. adjustment. This adjustment is for tractors below 109943------Hope this helps Lewie
Replies:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
