Tractor Talk Discussion Board |
Re: cleaning out ditch with scrape blade
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by davpal on June 21, 2006 at 09:56:50 from (216.93.94.101):
In Reply to: cleaning out ditch with scrape blade posted by Ditch Digger on June 21, 2006 at 08:20:01:
I have done this many times with my 9n and rear 6 foot blade. The blades have many holes to get them at just about any angle. You want it at the most angle it will go so it is almost touching the right rear tire. Now use the 3 point arm to put the right corner of the blade very low so the left side is pretty much up in the air. Added weight to the rear blade will help it cut better as will damp ground. I usually had my dad ride on the blade for me to keep the weight on the cutting edge and let me know how it was going. Also, don't keep looking back at what you are doing or you will have a crooked ditch. Just get it where you want it and keep looking straight forward and keep the ditch line very straight. Now go back and do it again and again in the same tracks until it is as deep as you want it. You can even come back the other way and do the other side too. It really works pretty good in some cases. Good luck.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|