|
Tractor Talk Discussion Board |
Re: Don't know about you guys, but
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mark on June 17, 2006 at 15:48:06 from (172.151.121.253):
In Reply to: Re: Don't know about you guys, but posted by Dachshund on June 17, 2006 at 14:10:26:
Let me throw you guys a curve for minute. I spent the best part of my life as a railroad engineer. The General Motors built loco's had most commonly a 16v645 turbo diesel (3000-4000 HP depending on configuration). So, that 16 cylinders at 645 cubic inch EACH....do the math. Now, the beauty of the beast is it operates at really low RPM's. 985 is max. and idle around 200. With all those power impulses they ran rather smoothly when idling. They will idle on about 5 to 7 gallons an hour! That engine at idle would probably make enough torque to rip Roy's axles out if they got hooked properly....let alone when wide open. The next thing is, a diesel locomotive is actually propelled by electric motors on each axle....referred to as a 'traction motor'. No gears...well, okay a gear off the armature and a bull ring on theaxle....but no transmission.....direct drive. As resistence builds due the speeding up of the armature.....which tries to force current back towards the alternator...a series of shunts take place....I forget the order, but something like from series to parallel, then series parallel and then parallel shunt..been too long ago.....do a google. Anyway, this is the manner in how big power is transferred....I think Euc's work on the same principle. So, if they had a Big Roy set up on diesel electric....and say just used a 2000 HP...oh say a 12V567, the work performed versus fuel spent would be quite reasonable.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
