|
Tractor Talk Discussion Board |
Re: Tractor loading ramp
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by someone used my name on June 15, 2006 at 19:01:08 from (204.227.221.148):
In Reply to: Tractor loading ramp posted by Lourens on June 15, 2006 at 04:12:56:
Hi Lourens, I just built a set almost exactly as you describe. Mine are 16" wide, 9'4" long. I used 3" channel on each side (can't remember the pounds/ft, but it is the heaviest 3") and used 2" x 2" x 1/4" angle for the cross pieces on 10" centers with 3" channel for the bottom cross piece. I mounted the angle with the flanges resting on the lower flange of the channel (inverted "V") I've since used them to load a Bobcat S220 which is about the same weight range you mention. There was no noticeable flex in the ramps while loading. The ramps are heavy, but I can easily handle them alone. I'll try to get a pic & post when I get a chance. HTH, Regards, DL
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|