Tractor Talk Discussion Board |
Re: Hay question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on June 15, 2006 at 06:16:11 from (66.244.90.5):
In Reply to: Hay question posted by Foligno on June 15, 2006 at 05:12:08:
Im NOT any forage expert but around here for the first cutting when the hay is tall with lots of stems headed out it takes good hay (height and thickness) to yield 100 small square bales per acre. If less thick or tall you may get like 60 or so. I would use Timothy as the tall stemmy hay but maybe mix it with clover under it??? If you get the first cutting off around Memorial day to mid June and get any kind of rain at all you ought to get a decent second cutting maybe 50 to 60 bales/acre depending on rainfall and fertilize. The second cutting is more of the tender short fine bladed less stems grass which stock seem to eat well and wastle little if feeders are used. That first cutting is more of the tall less tender stems. I like Orchard grass or Timothy etc mixed with clover versus Fescue hay. John T NOT any hay expert so take this fer what its worth NUTTIN
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|