Tractor Talk Discussion Board |
Re: baling hay......
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jim.UT on June 14, 2006 at 15:54:02 from (64.122.18.247):
In Reply to: Re: baling hay...... posted by Errin OH on June 14, 2006 at 14:53:28:
I can put 20 bales per tier on the trailer. I've had it as high as 3 tiers so that would make 60 bales. Last night I put 34 bales on the '69 Dodge flatbed and 50 on the trailer. Heavy load! The Dodge will do it, but not very fast! I never plug the 542 but I do miss a few ties. If I were doing the amount of acreage you're doing I'd look closer into it and fix the problem. As it is, I just stop and use a pitchfork to move the broken bales over to the nearest unbaled windrow, then keep going. I think my billhooks are about worn out. They have a nice hourglass shape to them.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|