Tractor Talk Discussion Board |
Dumb answers are still free.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by steve from mo - dangit! on June 13, 2006 at 12:13:48 from (168.166.54.11):
In Reply to: Dumb question or two?? posted by TimWafer on June 13, 2006 at 11:52:58:
You might try your university extension service. They"d probably have a handbook about canola growing, harvesting, etc. Most any combine would handle canola, although you"d be better off looking at what people are using for canola and how they like it. A swather would make a windrow out of the cut material. You could mow it and use a rake, but that"s another pass over the field and more grain loss. A combine pickup is used to literally pick up the windrow of cur grain and feed it into the combine. They don"t work as well if the material is not in a wondrow.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|