|
Tractor Talk Discussion Board |
Re: OT - Plumbing question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Joe-Bob/IN on June 13, 2006 at 04:56:27 from (216.241.134.131):
In Reply to: OT - Plumbing question posted by Dug on June 12, 2006 at 21:19:39:
I started on my house Jan 1st of last year and did all the plumbing myself. Got an estimate from two friends of friends and both quoted just over $2000. It only cost me about $800 and number of trips to Menards. Looked intimidating at first but was a piece of cake once you get started. Supply was really easy, I used all copper for supply. Inspector couldn't beleive I did it myself and only had three "T" fittings that had to be replaced with "Y" fittings. It took me about two weeks to complete DWV and supply but I also had other work to do. Saved at least $1200 and have a sense of accomplishment, not bad for a 26 year old farm boy.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|