|
Tractor Talk Discussion Board |
Re: Which Creates More Heat?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NC Wayne on June 11, 2006 at 14:06:34 from (152.163.100.74):
In Reply to: Which Creates More Heat? posted by in-too-deep on June 11, 2006 at 09:20:28:
Remember, there is a difference in the heat of compression and the heat of combustion. In your case, considering the your asking about starting a tractor that is "cold" then the majority of the heat, at least initially, is going to be the heat from compression, not from combustion. The heat from combustion doesn't begin til the engine is actually running. Think about the older machines with pony start, especially ones like the old CAT dozers with the BIG inline engines. The starting process with them for "normal" ambient temps was to actuate the compression release to get the engine rolling fast and then kick it in for it to start. In that case the ambient temp was high enough that you didn't need anything more than the heat of a single compression stroke to make it hot enough for combustion. If the temps were cold then you put the pony transmission in low gear for the needed torque and turned the engine with compression on the cylinders for a few minutes. This allowed the heat of compression to warm the engine components enough that the "heat of compression" from a single stroke wasn't drawn down too cold to cause combustion. In many cases the pony was also responsible for warming the intake air, the oil, and the coolant, but the end result was always to get the component temps of the engine hot enough that a single compression stroke would creat enough compression heat to cause combustion. Just my .02
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|