Tractor Talk Discussion Board |
Re: Work
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JMS/MN on June 02, 2006 at 20:46:52 from (204.73.106.15):
In Reply to: Re: Work posted by Allan In NE on June 02, 2006 at 15:56:59:
So what are the big boys in your area using- around here it's been FC's for decades. Sure, there was that spurt for Danish tine harrows for a last pass before planting, but too many thought they should use it as a first pass after fall tillage, and that did not pan out- just didn't work the ground enough. Until I got the heavy offset, the only time I used a disc was after moldboarding alfalfa. Disc was too much maintenance with the rocks we have. I can count broken pieces on the FC's over the last 30 years- next to nothing. Always run with a mounted tine harrow behind and it makes a good seedbed. If I could afford only one machine- the FC would be it. Never understood the fixation on discs.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|