|
Tractor Talk Discussion Board |
Re: Marvel Schebler - Idle Problem TSX-120 (Oliver
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jerry/MT on May 28, 2006 at 21:01:31 from (67.72.98.47):
In Reply to: Re: Marvel Schebler - Idle Problem TSX-120 (Oliver posted by Woo on May 27, 2006 at 21:09:44:
"With the governor disconnected from the carb it dies...." I'm not familiar with your governor linkage but were you holding the carb throttle shaft against the idle stop Make sure that you didn't miss the pressure balance port in the area of the choke. It's a drilled hole or slot and it vents the fuel bowl to the carb inlet so the air cleaner restriction won't affect the metering system. If it's plugged, your idle port will pull some fuel out and the pressure in the fuel bowl will fall and reduce the fuel flow. ALso, pull a plug wire and see if you have fat bluish spark. That's about all I have to offer.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
