Tractor Talk Discussion Board |
Re: Marvel Schebler - Idle Problem TSX-120 (Oliver
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Glen in TX on May 27, 2006 at 22:04:45 from (208.246.9.227):
In Reply to: Re: Marvel Schebler - Idle Problem TSX-120 (Oliver posted by Woo on May 27, 2006 at 21:09:44:
![third party image](http://www.tractorshed.com/gallery/pieces/v3445.jpg)
I agree with Bob that you may have missed a passageway someplace? Clean bowl and top mating surfaces well with steel wool seeing if you don't find a new plugged hole to clean out. If you are running those carbon core wires with a magneto get rid of them now! Okay on a battery dist. ignition but you will get more fire with metallic core wires. The hunting just sounds like carb problem to me yet. Make sure the new needle seat is sealing off good and float isn't bad or hanging up. New TSX floats can be had for a reasonable price and if float looks collapsed some replace it.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|