Tractor Talk Discussion Board |
Re: Water as fuel
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RAB on May 24, 2006 at 13:27:17 from (195.93.21.6):
In Reply to: Re: Water as fuel posted by Broomstacker on May 24, 2006 at 11:24:31:
Broomstacker, Yep. There is no such thing as a free lunch! Of course it takes exactly the same amount of energy to split water into hydrogen and oxygen gases as you then get while combining them back into water. Of course, you will finish up with less energy to use as processes are not 100% efficient and some of that energy will be lost somewhere - lost heat, transporting the energy (hydrogen), etc. However, if that initial energy source is free (solar) or otherwise wasted, then the system can be successful. Just remember that fossil fuels were originally produced with solar energy and our only other sources of energy are gravitational(eg tidal) and nuclear (eg geothermal). I suppose you could even say that thermo-nuclear bombs are made from water! As for improving the performance of engines - that depends. Getting more power by simply cooling the engine components to prevent failure does not necessarily help. Improving the efficiency of an engine at a given power output is another matter entirely. Gas and deisel and LPG are simply the best fuels (energy sources) at the moment because they are easily stored in the vehicle, easily topped up whenever appropriate, and are readily converted for their energy (compare with coal fired steam engines). That is all that needs to change with other energy sources; when it happens, then the oil companies will wince. Regards, RAB
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|