Tractor Talk Discussion Board |
Re: How do I do this (Math)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by J Schwiebert on May 20, 2006 at 08:27:47 from (209.143.51.230):
In Reply to: How do I do this (Math) posted by BUDD on May 20, 2006 at 08:13:29:
Budd: I did the rough calculation in my head. 50 pounds is close to 70% of 68 pounds. So if the dentisty of the weight is the same No handles bolt holes or any thing you want to cut off close to 30% so that should be between 75 and 80 square inches. It is 16 inches wide at the bottom you want to cut about 4-1/2 to five inches off. Later tonight I get set down with paper and pencil to do this. Good luck!
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|