|
Tractor Talk Discussion Board |
Re: Allan, others, power steering question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Harley on May 19, 2006 at 17:47:50 from (152.163.100.74):
In Reply to: Re: Allan, others, power steering question posted by Allan In NE on May 19, 2006 at 16:15:26:
Ya you two guys are the power steering gurus on here. I put that valve at 3 1/2 the day it came in about 3 months ago like you said then, and plumbed the other ports today, and no power steering. That's what makes me think I got it end for end. No there are no markings for in or out, but tomorrow I'll turn it around after I look through Keith's directions, and I'll just bet it works. There'
s just nothing like spending all day doing something just to find out that ya screwed it all up and gotta do it all over again tomorrow is there. Course you never do that I know. (Hydro trans.) So now I know how ya feel. But I'll get it, Thanks again guys , Harley
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
