Tractor Talk Discussion Board |
Re: OT: My Dog :(
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hurst on May 18, 2006 at 16:53:57 from (66.129.5.5):
In Reply to: OT: My Dog :( posted by Brad Wright of MO on May 18, 2006 at 13:32:36:
I lost my first dog a few years ago to kidney failure after his 2nd surgery to remove a cancerous growth on his thigh. I know 900 dollars is a lot of money and that it is going to be hard to come up with that, but at the same time, if I had the option of 900 dollars to have a HEALTHY dog for a couple more years again, I would spend the 900 dollars. I am probably more attatched to my animals than most on here, and that probably has to do with me being pretty young at 16 and having my animals there all my life when I needed them. Basically what I am saying is don't give up on her, but if the surgery is not a near for sure fix of her problems, then at the same time don't put her through any more pain. We put down another of our dogs while I was home for spring break after kidney failure because of old age. I hated to do it, but it got to the point on the day that we put her down that it hurt me to look at her. In a practical view, try to find a second opinion. Even if it means driving a little ways, it could very easily save you a lot of money. Also, don't be afraid to ask around for some small donations from your church or friends, I would help a friend in need of money for a family pet, especially one that is only 2 years old. You never will get all the money you spend on a pet back in cash, but you do get a whole lot of love, but do remember if there is nothing that can be done to get the dog out of pain, do what is best and put it to sleep. It is much nicer to have your dog fall asleep in your lap than to go be in pain. Good luck and my prayers are with you, your family, and your dog. Hurst
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|