Tractor Talk Discussion Board |
Re: Preserving wood on a flatbed trailer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by thejdman01 on May 17, 2006 at 11:41:01 from (152.163.100.74):
In Reply to: Preserving wood on a flatbed trailer posted by Markiee on May 17, 2006 at 09:46:55:
I know I will be shunned for going against the flow of what everyone else says but after running a roll back wrecker with wood floors and trying used engine oil on my own trailer, I would not under any circumstances put used oil on the dovetail part of the trailer and be careful about the flat part of your trailer. We all know oil floats on water. When the boards get wet from rain, the oil gets pushed to the top and it can get very slick very quick. Nice when trying to recover and winch dead tractors in the rain not too nice when trying to get up enough momentum to get up the trailer and you go over the edge.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|