|
Tractor Talk Discussion Board |
Re: Boil a carb?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rufus Windrow on May 08, 2006 at 16:49:33 from (64.42.242.25):
In Reply to: Boil a carb? posted by Bilko on May 08, 2006 at 16:35:43:
Now, I assume that you are a relative of the infamous Ernie Bilko (aka Phil Silvers) and that the carb you are considering to put to boil is from some sort of a military jeep from the sergeant's motor pool. Am I correct so far? Anyways, I have myself boiled carbs, my wife prefers I do it outside using the propane camp stove and an old pot but it does work. I use a couple of quarts of water and a couple of heaping teaspoons of laundry lye, get it mixed nice and heat it up to boiling until all the lye granules dissolve and in she goes. For rinsing, same operation without the lye, just plain boiling water. One reminder though, I don't think you should do it on pot metal carbs, just cast iron ones. I'm not sure about this last part but that pot metal is sometimes pretty sensitive stuff, and if you have a cast iron carb with a pot metal venturi, then don't boil the venturi, remove it first. There is a good article on rebuilding an MS carb in the articles feature here on the YT forum but be careful with the brass. It doesn't come out like it reads in the article. Heat the cast iron with a propane torch or in the barbeque before attempting to remove any brass and make sure any wrench or screwdriver is an EXACT and TIGHT fit or you'll have an expensive paperweight left over. Once again, I wouldn't use these directions with a pot metal carb. And say hi to Ernie for me if you see him around.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|