|
Tractor Talk Discussion Board |
Can you find my Dads Moline UB and Unstyled G Pull
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Harlan Kruger on May 05, 2006 at 13:05:10 from (67.142.130.21):
About 7-8 years ago or so my dad Harold Kruger sold his 1953 UB Moline Gas wide front puller to a Gentleman in Waterloo Iowa, The same guy also bought a John Deere GW from us that didnt run, he paid $2500 each for the tractors. The moline was repainted, it had a more of a brownish color rear wheels than red, it had fenders and a belt pulley. He also sold a John Deere 1939 Unstyled G. It was in the high 5000 to low 6000 serial number range. It was shipped new to Ottrano Iowa. It had cast rear wheels, small 12" or so front wheels. Some of the bolts and nuts were painted yellow to make them stand out, It had a chrome stack, It had an aluminum flatback, shutter, and was sold to a gentleman in New York, he started to restore it and found the head was cracked, I dont know much else about them, can anyone help with leads or know of these tractors? 507-437-6588
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|