|
Tractor Talk Discussion Board |
Re: M spinning on plowed sod.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on May 04, 2006 at 19:31:37 from (142.177.78.194):
In Reply to: Re: M spinning on plowed sod. posted by Mike M on May 04, 2006 at 18:48:39:
If you were running on a hard, slick surface, then what you are saying would be true. The greater ground pressure from the narrower tire would gain you traction. However, in field conditions, with a lug tire, it's all about contact plate area. The more the better. And the more weight on that tractor, the better, to a point. You can over ballast, but the principle problem here is a definite lack of ballast. Most people would dual up, and add more weight to tie the power to the ground. I seriously doubt that a narrower tire will help in field conditions. Rod
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
