Tractor Talk Discussion Board |
New bearings on Ford 601 Workmaster
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by springman55 on May 03, 2006 at 20:33:21 from (63.110.249.82):
I recently replaced all the bearings on the steering assembly of my Ford 601. The replacement bearings are made of delrin(teflon). The larger bearings in the steering housings went in fine....the smaller bearing on the steering shaft which replaces a bearing cup assembly was so tight my steering wheel will not turn. Has anyone had this same problem and if so what did you do to allow that shaft to turn freely? Someone at our local Ford dealer suggested using emery cloth to work the shaft smooth and also work the inside diameter of that bearing. Any help you can give is welcomed! springman55
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|