|
Tractor Talk Discussion Board |
Re: Lumina update,,,
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Lumina 3.1 on May 03, 2006 at 10:33:12 from (66.228.96.246):
In Reply to: Re: Lumina update,,, posted by Bob on May 03, 2006 at 09:16:07:
Tried that,, When the key is shut off, and run the jumper, it will lightly spark when the wire is touched to the terminals. When the key is on, it dont, nor it did not start. Sometimes, it will fire,,, thats if I short duty the key switch,, Instead of holding the start for a longer period of time to crank,, I will just barely hit the start and it would fire a few times and then,, after a few more times of doing this, it will go right back to doing nothing but crank over. Never thought of one injector being bad the whole setup wont work,,, Ill have a look at that. Bout the only part I havent replaced is the injectors, and the TPS sensor. Everything else has been swapped out, or new parts installed. NO trouble codes what so ever,,, Ill have a look at the key switch too,,, Thanks!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|