|
Tractor Talk Discussion Board |
Re: ford ranger
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on April 27, 2006 at 05:32:32 from (64.21.249.40):
In Reply to: ford ranger posted by twine on April 27, 2006 at 05:03:22:
On Fords of that era, typically the fender-mounted solenoid simply switches control power down to the solenoid on the starter itself. The fender-mounted solenoid could have failed, or the starter itself, or the solenoid wire could have fallen off of the starter. On the (+) battery terminal, are there 2 red wires leaving the lead cable end? Twice, on Fords of that era, I have seen where corrosion forms INSIDE the lead battery cable end, so the wires no longer make contact INSIDE the battery cable end. If you don't figure anything else out, while someone is holding the key in the start position, probe through the insulation on the cables leaving the battery terminal with a test light and verify there is power in the wires. Also, the negative cable could possibly be bad. Run a jumper cable from the (-) side of the battery to a good ground on the engine block, nad see if that helps. Post back and let us know what you find!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want � unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|