Tractor Talk Discussion Board |
Re: O/T: Removing Wooden Fence Posts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by T_Bone on April 24, 2006 at 23:20:03 from (4.240.42.204):
In Reply to: O/T: Removing Wooden Fence Posts posted by Blue3992 on April 24, 2006 at 12:43:53:
Hi Blue, I've used a pick-up and chain with good results. Just back the truck upto the post until you just touch the post then wrap the chain a couple wraps around the post close to the ground, then pull the chain tight then pull forward lifting the post straight up out of the ground. Yep the only draw back is it's a two person job. The chain only needs to be held hand tight if you take a double rap around the post. I use a 20ft 1/4" chain. The chain will not slip and makes for pulling the post and moving to another post very fast. Caution: If the chain has too much slack or is placed around the log too high then when the post comes out of the ground it will lean over and ding the tailgate. Ask my wife how she knows this. LOL T_Bone
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|