|
Tractor Talk Discussion Board |
Re: horsepower???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by davpal on April 20, 2006 at 23:00:40 from (216.93.97.125):
In Reply to: horsepower??? posted by Ags on April 20, 2006 at 19:28:17:
You can probably go up to 30 foot disk and field cultivator if you want to work the tractor hard. I used to pull a 30 foot white 272 disk (extremely heavy disk) with a 2-155 white. It was ballasted with two saddle tanks and a rear three point sprayer tank for incorporating spray. That tractor ran very good and had ample power to get the job done. It never ran out of lugging power on that disk. We also used a 4-180 white on that disk which seemed to have about the same overall pulling horsepower as the 2-155 but would pull the equipment through much nastier conditions. If you had a wet spot it was not an issue as much as the 2wd 2-155 which would get stuck lots easier if it was a wet field. We also pulled 30 foot john deere field cultivator with the 4-180 all day with no problems, up hills and through wet spots on occasion. 4-210 was aquired later and seemed about the same pulling power as the 4-180 but was more refined for creature comforts. Old 4-180 was dirty and clunky and old but seemed as reliable as can be most of the time. I would also use a glenco 11 tooth soil saver in the fall with no problems. If these old brutes can do it you should be able to handle 30 foot equipment and 11 tooth chistle plows. But if you already have 24 foot stuff I would not replace what you have unless it needs to be changed. Good luck.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|