Tractor Talk Discussion Board |
Cub Cadet 2160 Elect. PTO stalls engine when engag
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by forgiven_bob on April 15, 2006 at 15:43:18 from (205.188.117.14):
Hello I'm new to the group. And I'm not mechanically gifted but I try. I have a Cub Cadet 2160 w/16 HP Vanguard, now that when the electric PTO is engaged, it stalls the engine. The PTO pulley dose not spin easily by hand either. (did not try to before i had trouble, so not sure it should) I cut 2+ acres all last summer w/no problem, except near the end of the season when this PTO issue came up. Are there bearings that can be replaced? If the whole assembly needs replaced, where do I start? Any Help would be Greatly Appreciated. Thank you for your time. Bob L north east Ohio
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|