|
Tractor Talk Discussion Board |
Re: 1964 4000 ford
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JDknut on April 13, 2006 at 03:40:29 from (152.119.204.78):
In Reply to: Re: 1964 4000 ford posted by tim(sd) on April 12, 2006 at 20:16:45:
It is a 1965 or later, if it has the squared off hood and a 3-cylinder engine. The 65-68's had a separate rectangular grill with a white insert covering the top 1/3 or so of the whole front area, on the 68's and later the grill was just one big rectangle. Depending on the type of PTO, the PTO turning even when disengaged, might not be too serious, the frictional drag of the oil in the system can let the shaft turn when disengaged with no load. I have seen that with a TLB set up to dig and the back end raised with the wheels off the ground on the outriggers, the rear wheels will sometimes turn even when the machine is not in gear, this is just the churning of the oil. But if it is a dry clutch PTO you might want to check the clutch adjustment. just my $0.02.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|