|
Tractor Talk Discussion Board |
Re: vented gas cap for 800 Ford
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scott PA on April 11, 2006 at 18:14:03 from (152.163.100.74):
In Reply to: vented gas cap for 800 Ford posted by abane on April 11, 2006 at 10:51:54:
Ford came out with a free safety gas cap exchange offer in 1986 to make sure all the 1939-1982 Ford gas tractors get the new style large vented cap with spill prevention in a rollover, New Holland now continues to offer it also, take your current cap, the hours from the meter, the model# and the hand stamped serial number with a diamond at each end located at the top left front corner of the transmission housing straight below the air cleaner to your local New Holland dealer and they will give you the free safety cap with a long plastic neck and large vent holes in the top, if they are a new dealer and do not know anything about it tell them to refer to service bulletin 1993/10-T2 to get reimbursed from New Holland, keep the gas level below the bottom of the plastic neck of the new cap..
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|