Tractor Talk Discussion Board |
Which way does a distributor spin?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt from CT on April 11, 2006 at 10:21:44 from (68.118.199.56):
Ok...I'm not sure if I can still call myself a young buck at 35... But I certainly wasn't raised working with carbs & distributors :) I had a stupid moment, and when I replaced the cap & rotor on my TO-35, I **thought** I memorized where the wires went. Yes, I **knew** better and **knew** to write them down, even though I didn't... I know the firing order should be 1,3,4,2 (per several references). I did that clockwise around the cap...I guess I just fundamentally assumed the rotor spins to the right (clockwise). Runs like crap, for short periods, backfires and dies. I found this good diagram: http://www.fergusonenthusiasts.com/wiring/T0MF35_F40_MHMF_50_MF_65_12V.pdf If I'm reading it right, it's telling me the rotor goes counter-clockwise to achieve the 1,3,4,2 order... So am I correct in switching the wires around to follow the pattern on the diagram?
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|