Tractor Talk Discussion Board |
building up pad site for barn
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nathan in Texas on April 11, 2006 at 08:55:10 from (216.167.183.158):
Well, I posted on this a while back and also posted on the tractorbynet forum and got some good advice and ended up going ahead and doing the pad site on my own. I also talked with a local concrete worker and ran my plan by him and he said that's how he would do it. In retrospect I only saved about $400 doing it on my own, but I think I ended up with some good experience and went out and bought $325 worth of tools to reward myself! ;-) I hired a college kid to help me and was VERY impressed with his work ethic. It really was refreshing to see a hard worker who showed up early and stayed late instead of all the bad things you hear about kids today. I rented a tool called a jumping jack or whacker packer that is gas powered and jumps up and down with a flat shoe and really packs the dirt down well. It puts out 3,000 psi of pressure. I had the college kid run the jumping jack while I drove the tractor! ;-) I ended up doing 4 layers and packed them down with the tractor and then the jumping jack between each layer. I ended up having to wet down the dirt before packing down each layer also. The best method seemed to be leveling out the dirt with the tractor, spraying it down really good with the hose, getting a big scoop of dirt in the bucket and driving back and forth over the site, then running over it a couple times with the jumping jack. Then repeating. Here is the before picture: 
And here is the after picture: 
One more after picture: There are a couple more pictures in the same directory if you want to check out some of the progress pics I'll include them in a link below.
Overall it was a lot of work. Took about 20 hours but it does give you satisfaction to get something done like that. Thanks again for all the input. Nathan
Replies:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|