Tractor Talk Discussion Board |
Re: Cleaning connections
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave H (MI) on April 07, 2006 at 07:34:01 from (64.12.116.74):
In Reply to: Cleaning connections posted by Andrew Betzner on April 06, 2006 at 20:13:29:
Depending on what you are cleaning you could ruin your connections with abrasives. It is not unheard of for contacts to be plated with special materials to assist in conductivity and resist corrosion. When I repair an old jukebox I use a zero residue contact cleaner and run a dollar bill between the contacts. I use the same procedure on old Lionel accessories. Could be you will be alright with greasy tractor stuff being a little tougher on it but I would still go with a zero residue cleaner. Anything else just attracts more crud when it dries.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|