Tractor Talk Discussion Board |
Re: Farmall M........water in oil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by OK PSU Kid on April 06, 2006 at 08:24:07 from (156.110.78.2):
In Reply to: Farmall M........water in oil posted by Buss66 on April 06, 2006 at 08:12:28:
I'm not a master mechanic but I think if you had a hole in a sleeve you would experence loss of compression, and would run like crap. Try a compression test. Then if everything comes up even pull the head and look at the sleeves, if your head gasket looks good you can use spray-on Copper Seal and it will help seal it again(cheaper than a new gasket). Might check the torque on the head bolts before you pull it off. But be sure of the problem before you buy an expensive sleeve. good luck OPSU Kid
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|