Hardware identification

Posted by Andrew Betzner on March 14, 2006 at 16:57:45 from (172.149.136.224):

Ok this is a part used on all kind of things, not just tractors. From its side profile it is a T upside down. it is tapper from front to back. They are used when you have a shaft and a part going around it there is a slot where you pound of these until it locks so the two parts are joined put if you remove this pin then can be seperated, they are usually really small and I need two of them for my brakes for my Farmall H but I can think of what that dang things are called. Do you know what i'm talking about?

Replies:

• Re: Hardware identification NC Wayne 17:36:21 03/14/06 (0)
• Re: Hardware identification Allan In NE 17:06:08 03/14/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]