|
Tractor Talk Discussion Board |
Re: Tough Repair Job
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JT on March 13, 2006 at 12:00:58 from (70.226.214.39):
In Reply to: Tough Repair Job posted by 37 chief on March 12, 2006 at 21:27:55:
this was not the dirtiest job, but putting a hydraulic hose on a forklift or changing a starter on the same forklift rates right up there with the most difficult job ever done. Had no lift, so it was jacked up about 6 inches off the ground and and had to reach up under the forklift to do this. Was an interesting job to say the least.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|