Tractor Talk Discussion Board |
Re: Aftermarket mower blades
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fred Martin on March 01, 2006 at 10:53:42 from (69.218.163.54):
In Reply to: Aftermarket mower blades posted by Hurst on February 28, 2006 at 16:29:25:
I had a similar problem when I went to buy blades for a RM-59 Woods finish mower. They were $45 a set and the local farm store had the same blades for $15 but they were made to turn the other direction. Being that I live by myself and no one else around...after buying the new blades....I sliced off pieces from a new push mower blade that I had and welded them on and sharpened them....then balanced and run for years like that. In fact they"re about worn out now and I can"t find the new ones...I used stick low hydrogen rod on them and I have welded for a living....so be careful doing this...it isn"t recommended! Fred OH
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|