|
Tractor Talk Discussion Board |
Re: Aftermarket mower blades
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hurst on February 28, 2006 at 19:49:56 from (66.129.5.5):
In Reply to: Re: Aftermarket mower blades posted by The real JD-Tractor on February 28, 2006 at 19:09:04:
I would assume that if the blade was like that it would not be allowed to be sold with all of the safety standards anymore. I am not trying to just save a buck using cheaper material, I am trying to figure out if I am just paying for a gross dealer and company markup when I can get the same exact blade for a lot less from a whole seller. The measurements are all the same. I just figured that anymore all of this stuff is outsourced to just a few providers, most being overseas no matter where you go any more. I understand your opinion. I don't think my question was written very clearly. I am just wanting to know if these blades are the same or very similar to the OEM blades. Thanks again Hurst
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
